|Click on the thumbnail images to view in full size|
|This is what you start with-- the complete kit including enclosure, hardware, and a detailed instruction manual. The WM-2 kit is not difficult, and will take the average builder approximately 4 hours to complete.
|Here's the completed circuit board, before attachment of the connecting wires. Note that the two toroids are large and have only a few turns-- no problems even for a beginner. All component and connection points are silk-screened on the board, and the solder side is masked for your convenience|
|Everything fits neatly inside the WM-2 case, which is pre-punched to very precise tolerances. Alignment is simple, using a Digital Voltmeter, and there are only a few adjustments to make. An RF source is NOT required for alignment.|
|Ta-daaaa! The finished product, a laboratory quality instrument and YOU built it!|
|Copyright © 2003,2004,2005, 2006, 2007 QRPproject.
All Rights reserved
Webmaster and QRPproject Support
This homepage is owned by:
QRPproject Hildegard Zenker QRP and Homebrew International
Bank: Berliner Sparkasse BLZ 10050000 Konto 1120048733
IBAN Number: DE83100500001120048733
Responsible according to German Law § 6 MDStV: Peter Zenker, Molchstr. 15 12524 Berlin
|Amateur Radio against Racism
Nazi leave Internet